CON-E-CO HRM-12 Mixer

Capacity
12 cubic yards

MIXER DRUM
1” polyurethane drum liners
1” polyurethane blade liners
3/4” steel drum shell
3/8” steel inlet and outlet cones
Bolt-in blades
Bolt-in spider blade support

DRIVES
Four 50 H.P.T.E.F.C. motors
Enclosed gear reducers
High capacity friction drive
Retractable 120/240-volt, single-phase emergency drives

ELECTRICAL SYSTEM
Variable-frequency reversing drive control
Climate-controlled NEMA 12 enclosure
Circuit breaker main disconnect
U.L. Listed panel
Knife switch at each drive motor

INLET CHARGING HOPPER
Powered 36” travel retractable assembly
6” water manifold with dual 4” outlets
One-piece urethane charging seal
38” diameter inlet
1” urethane hopper liners
10” diameter cement tube

DISCHARGE HOPPER/DUST CONTROL SHROUD
Truck mixer charging shroud
Provision for camera view and light port
Dust control suction inlet ring
Retractable inspection door
46” diameter discharge

NOTE: in accordance with CON-E-CO’s policy of constantly improving its products, these specifications are subject to change without notice.